IV Techmould have just installed two brand new 2K 160T Engel injection molding machines to support increased demands from current customers and to support potential new business. The machines have 160 ton clamp force and Engels W version for the injection units to minimize the machine footprint and increase accessibility around the machine and also Engels unique tie-bar-less technology for maximum flexibility of mould dimensions. They are also equipped with Engels ECODRIVE for excellent energy efficiency and low noise.
Managing Director Fredrik Carlsson comment the investment:
“We have been running with very high utilization in our 2K injection moulding machines for quite a while and then when some existing customers indicated higher volumes from 2017 we took the decision to buy two new Engel 2K injection moulding machines to increase our capacity to meet the increase in demands for some existing business but also to open up capacity for new 2K injection moulding business”
IV Techmould have long and extensive experience in 2K injection molding.
Fredrik Carlsson continues:
“We invest further in our 2K injection molding capacity by adding 2 brand new Engel 2K injection moulding machines to our already existing 2K injection moulding machines, this means that close to 20% of our total machines capacity at IV Techmould are 2K injection moulding business. 2K injection moulded parts are a big part of our business and a core competence at IV Techmould. We run 2K injection moulded parts for all 3 of our market segments, Automotive, Industrial and Consumer”
Industriverktöy i Sverige AB
c/O Anyo AB
Ideon Science Park
223 70 Lund